AQ8423Z光放大器分析仪，它覆盖C带和L带波长，能与AQ6317系统光谱分析仪配套。它可精确地测量噪声指数NF和光链路中光放大器的增益，分隔ASE光噪声和经过光放大器放大的光信号，并能达到最小光路间隔25GHz的最佳效果。当将AQ8423Z与AQ6317B联合使用时可测量多达200个光路的NF图形。最近又推出新的多波长测量仪，一次可完成多达256条光路的波长测量。总之，DWDM系统的测量技术和测试仪表正向着更多波长、更好的波长测量精度和可分辨出更小的光路间隔，即向着能满足未来更高波分密度、更巨大的网络容量的传输设备的要求发展。
Specifications
Wavelength range 1) C-Band mode (1520 to 1580 nm)
L-Band mode (1560 to 1620 nm)
DUT input power range 2) -45 dBm to +10 dBm
DUT output power range +24 dBm or less
Accuracy 3) Gain ±0.2 dB
NF ±0.3 dB
DUT input power ±0.2 dB
DUT output power ±0.2 dB
Reproducibility 3) Gain ±0.1 dB
NF ±0.2 dB
DUT input power ±0.1 dB
DUT output power ±0.1 dB
Applicable fiber Single mode 10/125 μm
Applicable optical connector FC (SPC)
Minimum channel spacing 4) 25 GHz
Maximum channel 4) 200 channels
Measurement time Approx. 5 minutes (40 channels)
Warm-up time Approx. 1 hour after power on
Measurement function Wavelength dependence, input power dependence, stability
Display function Wavelength-Gain, wavelength-NF, input-output, input-Gain, input-NF, time-gain, time-NF, time-input,
time-output, measurement data list, 1-, 2- and 4-waveform display
Calibration function Input power, output power, OSA effective resolution, DUT delay time
Data storage FDD (3.5-inch 2HD, 1.2/1.44MB), internal memory (for 32 waveforms)
Printer Built-in high-speed printer
Interfaces GP-IB (2-ports), video output (VGA compatible)
Display 9.4-inch color LCD
Power requirements AC100 to 120 V, AC200 to 240 V, 48 to 63 Hz, approx. 200 VA
Environmental conditions Operating temperature: 15 to 35°C
Storage temperature: -10 to 50°C
Humidity: 80% or less (no condensation)
Dimensions and mass Approx. 425(W) x 222(H) x 450(D) mm, approx. 20 kg
Notes
1) Either C-Band mode or L-Band mode
2) Maximum input power is related to the output power of light source.
3) ±1°C, between 15 and 35°C
4) In conbination with AQ6317B optical spectrum analyzer
深圳市嘉惠捷科技有限公司
黄先生
手机:13928415151
TEL:0755-89437676
MSN:seanhuang82@hotmail.com
Mail:test-e@test-e.com
QQ：627906231
Http://www.test-e.com
